Tissue Box instructions
Two pieces of fabric of you choice each 15 inches square. One piece will be outside and other inside. Sew these right sides together using a quarter inch seam leaving about a 3" opening to turn. After you turn then press and sew 1/8 inch with a thread that goes with both sides. ok, now take that square and fold up for both top sides to meet. like this picture [ATTACH=CONFIG]443597[/ATTACH] Now you measure 4" from bottom left corner and up left side and mark. Then measure from bottom left corner over 4 inches on bottom fold and mark. Lay a ruler down and draw a line from one marked area to the other and sew on that line through all thicknesses. Now you do the same on the right side and here is a picture again. [ATTACH=CONFIG]443598[/ATTACH] OK now is the trickie part. Now fold the other two edges two together and do the same measure and sew from the folded edge up the left side and mark 4 inches and sew across just like you did on the other two sides. [ATTACH=CONFIG]443600[/ATTACH] I covered the bottom right with a coaster so you would not get confused any more than you might be as of now. When you. After you get all four corners sewn like this you should be able to look in the finshed product and see a square bottom were the bottom of tissue box sits. Put the tissue in the box and fold two sides on one side and pin wear you want or button. Do the same to the other side and then take tissue out while you sew the buttons on. This is what you should have. [ATTACH=CONFIG]443601[/ATTACH] I hope you can understand this. I have never done this before. Suzanne