I just went to the old thread and saw this:
Printing with software – in order to avoid wasting so much paper when you print your patterns using software you need to “move” the pieces to one side before printing. Turn your paper around and print the next block at the other end of the paper. ..from NDQuilts…”If you are prining just the block outlines the yes you can fit two blocks on a page. I adjust the top margin as narrow as my printer will allow and print block 1, then rotate the paper to print block 2. If I remember you cannot print any text in the header.
I also would like to print 2 blocks to a page, but can't move my blocks in the software. Is it because my software is an old version? The option to move is not available in the print preview screen. Am I doing something wrong?
thanks,
cindy