mckwilter

When I do signature blocks, I make a "frame" to place the fabric in. The cut out area is 1/2" smaller than the finished size of the signing area of your block and would be the size of your writing area. On the inside of the file, you glue a piece of fine grit sandpaper the same size as your block to place the fabric on so that it doesn't slip while it's being written on. So, if the signing area of your block is 4" square, the cut out on the front of the folder would be 3-1/2" square. Then trace that onto the inside of the file folder and cut a piece of sandpaper 4-1/2" square, and glue it over the traced square . You can make several of these so that more than one person can be signing a block at a time. I wrote directions on the folder and hope you can read them.

[ATTACH=CONFIG]485655[/ATTACH][ATTACH=CONFIG]485656[/ATTACH]