I was asked to do a tutorial on my Dresden Kaleidoscopes. I can give you the very basics.
I do send out free templates for this if you send me your postal address in a pm.
Here is the fabric I used for this lesson
[TABLE="class: aextbox"]
[TR]
[TD][ATTACH=CONFIG]489857[/ATTACH][/TD]
[/TR]
[/TABLE]
Trace the elements in the fabric
onto the clear plastic template
so you can see to place it on the
next repeat
Trace around the template for the blade
[ATTACH=CONFIG]489858[/ATTACH]
Here is the template so you
can see my tracing.
Place the template on the next repeat
match the tracing to the elements on the fabric
Trace around the template
[TABLE="class: aextbox"]
[TR]
[TD][ATTACH=CONFIG]489859[/ATTACH][/TD]
[/TR]
[/TABLE]
Here you can see where the repeats are
[TABLE="class: aextbox"]
[TR]
[TD][ATTACH=CONFIG]489860[/ATTACH][/TD]
[/TR]
[/TABLE]
Okay cut out the blades and sew them together
[TABLE="class: aextbox"]
[TR]
[TD][ATTACH=CONFIG]489861[/ATTACH][/TD]
[/TR]
[/TABLE]
Here you can see 4 blades sewn together
and the design starts to show up
[TABLE="class: aextbox"]
[TR]
[TD][/TD]
[/TR]
[/TABLE]
You will need 10 blades if you use my templates.
I like to sew 5 together and then trim if need be to have a straight edge
then sew both halves together.
Here are a few of my dresden kaleidoscopes
[ATTACH=CONFIG]489851[/ATTACH]
This one was roosters
[ATTACH=CONFIG]489853[/ATTACH]
this one was cats and the
center looks like a spider to me
but it is really cat tails
[ATTACH=CONFIG]489854[/ATTACH]
[ATTACH=CONFIG]489856[/ATTACH]