Originally Posted by
ndnchf
Here is the bumper post on the back. It is 2.5" tall from the table surface to the top. The rubber on top is about 3/16" tall, but is a bit squished.
Thank you, so very much.
It is a little different than I was imagining. I was thinking that it was a screw through the table top and into the wood. It has been a while since I have seen the top
. I'm kind of estimating that the bottom bulge (that shows above the table) is approximately a little over an inch in diameter and the wood under the top bumper is probably about 3/4 to 7/8 inch in diameter????
Thank you, again.
Janey - Neat people never make the exciting discoveries I do.