Do you tilt your machine?
#64
Super Member
Join Date: Nov 2009
Location: jacksonville bch
Posts: 2,065
Originally Posted by jackie o.
I always try to remember to tilt my machine also. I use the inexpensive rubber door stops that you can buy almost anywhere. I like them because they "grip" the machine, and you can easily adjust the angle of the tilt. Hope that's helpful.
#67
Super Member
Join Date: Jul 2010
Location: Central Willamette Valley, Oregon, USA
Posts: 7,695
Originally Posted by bjeriann
I put a 1x3 piece of wood under the back of my machine. It likes to slide as I sew. I'm going to try the door stops. Great idea, thanks. Have you priced the clear plastic ones they sell? They are around $70 last time I looked.
#69
Senior Member
Join Date: Feb 2010
Location: Austin, TX
Posts: 847
Originally Posted by quiltmouse
someone here sells "sewing machine lifters" which is a little slant table to set on your work surface. (might be DebbieUmp...)
I bought 2 rubber doorstops at walmart.
I bought 2 rubber doorstops at walmart.
#70
Super Member
Join Date: Jun 2011
Location: near Peoria Illinois
Posts: 1,638
I know it is supposed to be ergonomically better, I just haven't tried it.
Think I'll try the door stops of 79 cents. I could always use them elsewhere if I don't like it.
Thanks for sharing! This board is great!:)
Think I'll try the door stops of 79 cents. I could always use them elsewhere if I don't like it.
Thanks for sharing! This board is great!:)
Thread
Thread Starter
Forum
Replies
Last Post
joym
Main
80
01-09-2013 01:37 PM
AngelinaMaria
Main
51
10-19-2011 01:23 PM