Wintersewer

If you are referring to my message...?????....no. The table is a full inch thick and is still very sturdy.

Deanne

Just my opinion, now. But i would turn myself to the left and use the "typewriter" side of the desk. Already lower and you don't have to cut anything, loose your valuable drawer. You can bring up something else to lay the bulk of your quilt on when you need that area. Maybe and ironing board or a card table, etc. Again, just my opinion. You must do what feels right to you.

SingerSewer

On the QIAD site there is information on how to turn a wooden table into a sewing table. This is the link to the page http://www.quiltinaday.com/freepattern/ and it is listed as "How to Make a Sewing Table from a Farm Table" and is located on the lower right hand side.

KyKaren1949

Can't you cut the legs down to make it shorter?

quaint4900

Very nice. I took my daughters desk, which she is letting me use right now, that is an oak desk with a pull out tray for setting a keyboard on, and I use the pull out tray for a simple pressing table to iron seams on while making blocks. It works great and is very handy.

Mitch's mom

I would cut the legs of the desk. If you put masking tape across the area you are cutting just above the cut line it will keep the wood from chipping and fraying which is what probably happened with your door.

AshleyR

Ok. My husband didn't want to cut into the desk. I found a sewing table for $5 so we brought it home. I removed the screws from the hinges that holds that table top. I didn't want a hole in the top, so we cut the back of the top as you can see in the pictures. I removed the back of the table and am using it as the front. My legs don't fit under a cabinet!

We cut the table top down to fit and supported it with discount lumber from Home Depot. All we did was screw them into the sides. We had to cut the corners (pun not intended!) for the table top; you might be able to see that in the pictures. Because I removed the back, we had to reinforce the legs. There is white tape in the front. I added a "bumper" onto those corners so my legs wouldn't get all scratched up and poked! I added a piece of vinyl to the left of the machine to cover the nails and splinters and help the quilt move.
The height is almost perfect. At least I know I can cut the legs down if I need to. That is seriously not an option with that desk. My husband told me today that if we move, it's staying here. It weighs about 7billion pounds.

AshleyR

Well, crud. without getting into too much details... it doesn't work. Back to the drawing board!

gardnergal970

Make the desk your cutting/ironing table. Install more lights on the left wall and find a table more near the correct height for you that can be adapted easily for your machine and sew there. It would probably cost you less and be much more comfortable. I did see the mechanism that is used for the drop table that you see here http://www.hornofamerica.com/product...s&productID=96. I have also seen the ones that aren't airlift but I don't remember where. Keep researching and you will find something that will satisfy your needs. Good luck.

romanojg

Instead of the tape that isn't stable; it will move with vibration. Why not take the wood that is cut out and mount it with metal brackets low enough for your machine. It would be more stable for sewing.