plainpat

My Olfa 60mm cutter has started leaving 3-4 uncut threads every time it's used,even with a new blade.So time for a new cutter. Have a couple other sizes,so has to be the 60mm size.
What brand do you like & why? Does anyone use the Ergo? Safety is a factor.Thanks for your help.

sandrab64

Interesting. This is the same thing that happened to me this week...60 mm Olfa cutter, new blade, but leaves an uncut span of a few threads. I have to go over the cut every time. Is it really the cutter or could it be a defective blade?

BellaBoo

I could be your mat that need replacing. A new blade should make the cutter almost like new. I rarely use a 60 mm cutter so not familiar with that size. I like the Olfa Ergo rotary cutter.

Holice

contact customer service at Olfa and ask their advice.

PaperPrincess

It could be a defective blade, but I would check the mat first. cut in an area that you normally don't use. or flip it over.

qbtexas

Is your mat older? I just had the same issue, but the mat I was using has seen its share of work over the years and I think the older mat affects the cut.

plainpat

I had a pkg of 5 blades recieved as a gift.Just put a new blade in last wk,still have one left. Need to cut a lot of small pieces & this having to go back over uncut threads is a pain.

rebeljane

I would tend to believe it is the cutting mat and not the blades

QuiltnNan

my mat is old with deep cuts, so i get the uncut threads all of the time. when i use my other mat, the blade works just fine.

plainpat

Thanks all. I tried a new mat,didn't help,so has to be the blade.With a Joanns coupon,a new cutter makes sense.