ironing board cover material
#12
Super Member
Join Date: Jun 2008
Location: British Columbia
Posts: 2,302
My DH made a rectangular board to fit over my ironing board. I covered it with one layer of batting followed by aluminum foil and finally a heavy fabric - don't know the name but it's smooth and could be used to cover furniture. Probably cotton duck. I didn't want my ironing surface too soft and the aluminum foil reflects the heat onto the bottom side of whatever is being ironed. The fabric is stapled to the board and I haven't changed it. Maybe in another ten years.
The whole things is firm and taut. I know the foil works because I have to move my small pieces around as the board heats up when pressing a lot of seams open.
The whole things is firm and taut. I know the foil works because I have to move my small pieces around as the board heats up when pressing a lot of seams open.
#13
Junior Member
Join Date: Aug 2020
Posts: 278
#14
Thank you all for your comments. The Sharon Schamber video was especially helpful. I decided to use the cotton duck. I know that the silver cloth would be a good choice too, but I already had the duck and didn't want to buy new supplies. I finished making the pillowcase for the top today, and my daughter helped me pull it onto the board. I had intended to close the open end with Velcro, but I decided just to tuck it under instead, at least for now. The duck did shrink - a lot! - when I washed it.
Don't look at all that mess on the cutting station behind the dresser. I'll clean it up, I promise!
Don't look at all that mess on the cutting station behind the dresser. I'll clean it up, I promise!
#15
Super Member
Join Date: Jul 2013
Location: Houston, TX
Posts: 9,533
Nice ironing station, Dunster! I love that it has all the nice drawers. I also have "shelf envy". I love all your shelves with your fabrics on them. They're so pretty.
Mess? That not much of a mess. That's sort of the normal for my cutting area! lol
Mess? That not much of a mess. That's sort of the normal for my cutting area! lol
#17
I would lean towards something heavier like the cotton duck that is well washed and pressed. I used woven striped ticking before which was quite nice to use for checking blocks for straightness while pressing. Currently I have a linen which has been the most resistant to the heated iron.