Sewing desk for 6500
12-30-2012, 05:29 AM
#21
Super Member
Join Date: Apr 2011
Location: SW Ohio
Posts: 2,103
I just bought a sewezi table and love it. Some people think they are expensive because there are no drawers or storage. However, they are super portable and come with an insert specific to the sewing machine you have.
Here is the link to the site http://www.seweziusa.com/
Here is the link to the site http://www.seweziusa.com/
12-30-2012, 07:20 AM
#23
Super Member
Join Date: Aug 2010
Location: Brisbane, Australia
Posts: 3,453
My machine is about 5 years old and I have finally decided that FMQ would be much easier if I had a regular table to insert my machine. Anyone have any ideas where I can find one that does not cost a furtune. I don't need drawers, etc--just table where I can inset my machine. The ones I have looked at are quite expensive and I really don't need all of the extra drawer space nor can I afford to pay for it.
Just like the one in the first post on this page.
12-30-2012, 07:25 AM
#24
Super Member
Join Date: Aug 2010
Location: Brisbane, Australia
Posts: 3,453
Hi, Redbreast, I'm in the same boat - there are beautiful Horn cabinets here in Australia but I can't justify the cost of a new one and the older ones on ebay don't fit my Pfaff, so I'll be following your thread with interest. I do recommend looking on ebay but check the opening measurements carefully. Good luck!
12-30-2012, 09:04 AM
#25
Super Member
Join Date: Oct 2012
Location: West Central Texas
Posts: 2,586
I have the original Gidget and like it for my regular Janome. Where are you getting the inserts from for the Gidget II? I've looked at a couple of places that sell the Gidget II, but haven't seen any mention of inserts.
12-30-2012, 09:32 AM
#27
Senior Member
Join Date: Dec 2010
Location: Central VA
Posts: 413
12-30-2012, 09:47 AM
#28
Super Member
Join Date: Jan 2010
Location: Pacific Northwest
Posts: 9,276
We are starting on the renovations of the sewing annex. It's the other room my Long arm frame and machine sit reside.
He is going to add a cut out and brace up the lowered section where the machine sits in.
He is going to add a cut out and brace up the lowered section where the machine sits in.
12-30-2012, 09:49 AM
#29
Super Member
Join Date: Jan 2010
Location: Pacific Northwest
Posts: 9,276
12-30-2012, 12:13 PM
#30
Super Member
Join Date: Apr 2010
Location: Central Florida
Posts: 1,804
I bought an executive desk at a local ReStore (Habitat for Humanity). I think I paid about $25. It's about 6' long and 3' deep. I sit my machine on top but I could have my DH cut a hole in the top for my machine. The desk has a center drawer that I could sit the machine on if I have the top cut out.
Thread
Thread Starter
Forum
Replies
Last Post
