Does anyone know????
#2
Super Member
Join Date: Sep 2011
Location: East Tennessee
Posts: 1,102
#6
#7
Super Member
Join Date: Nov 2009
Location: Ontario, Canada
Posts: 1,991
Viking machines seem to need Viking feet which are always more expensive than ordinary short shank generic feet. The short shank feet which are fine on my vintage Singers will not fit my Husqvarna/Viking machines. Even the walking foot from my Husqvarna Prelude (class 5 Viking) will not fit my Husqvarna #1+ (class 1 Viking). I found that really annoying!
#8
Oh no. So you're telling me Shelbie, that I should keep my old Rose forever? I like the idea actually. She's a really good machine. I'll just make sure I check out the feet before I buy a newer one. Thanks
#10
Super Member
Join Date: Apr 2012
Posts: 1,165
I think the older vertical bobbin machines might have been more forgiving. I used to use Elna shank and feet on a Pfaff 1471. Bought a Viking 1+ and that used the same feet. Some also fit a Brother PC 6500, and an Ellure. I've used other low shank feet with ankle attached on all machines. It could have been stitch width. Earlier machines were all 6mm. Pfaff came out with the 1473 and changed to 9mm. I have some 6mm feet, but use the twin needle button for safety.
Just make sure the needle and the hole line up.
Just make sure the needle and the hole line up.
Thread
Thread Starter
Forum
Replies
Last Post
TnBecky
General Chit-Chat (non-quilting talk)
25
02-28-2014 12:41 PM
msjangles
Main
10
02-10-2011 10:56 AM
ButtercreamCakeArtist
Main
30
03-27-2010 09:13 AM
Does anyone know a quilt block Quilt starts with Margeret's Choice???Quilt STUCK IN PROGRESS Mmmmmmm
ArtquilterNEWWAYtoQUILT
Main
4
11-01-2007 11:57 AM