Storing quilting rulers on angled downwards wall
11-09-2024, 08:10 PM
#1
Member
Thread Starter
Join Date: Mar 2014
Location: Needham, MA
Posts: 15
Storing quilting rulers on angled downwards wall
I have been thinking about storing rulers this way by mounting nails in a board that are angled higher than parallel to the floor with some sort of clear acrylic (magazine type vertical usually) mounted holder below. Perhaps with acrylic midway bands halfway between the hooks & bottom acrylic for shorter rulers, or maybe just acrylic band across under hooks at several intervals. Has anyone used this unusual space this way and can I see pic(s) please if you have. I am a c
Cape Cod style house dweller but so many of you are attic dwellers too!
Cape Cod style house dweller but so many of you are attic dwellers too!
11-10-2024, 08:48 AM
#3
Power Poster
Join Date: Apr 2011
Location: Ontario, Canada
Posts: 18,340
The only way you will know, is to give 'er a try! 
But to me, what would have to be done to keep the rulers in place, would not be worth the annoyance!
My rulers stand up in a bin at the wall end of the cutting table . Actually two bins, so that the smaller ones (6-1/2" and smaller) do not disappear behind the height of the deeper bin. I can easily see which is which. The two large squares (16-1/2" and 20-1/2") slide in next to the cutting table on the floor.
But to me, what would have to be done to keep the rulers in place, would not be worth the annoyance!
My rulers stand up in a bin at the wall end of the cutting table . Actually two bins, so that the smaller ones (6-1/2" and smaller) do not disappear behind the height of the deeper bin. I can easily see which is which. The two large squares (16-1/2" and 20-1/2") slide in next to the cutting table on the floor.
11-10-2024, 09:27 AM
#4
Super Member
Join Date: Jul 2010
Location: Ontario, Canada
Posts: 3,970
I also live in a Cape Cod style house and went up to the dormers to have a look. I don't really see a benefit. I think the rulers would be difficult to get in and out of a magazine holder type fixture on a slant. Mine are on hooks on a piece of pegboard. Works for me.
11-11-2024, 08:16 AM
#6
Power Poster
Join Date: Jan 2011
Location: Southern USA
Posts: 17,810
If you have the room, a revolving floor stand will hold drawers full of stuff. Everything is visible. The only con is the item I want is always behind a dozen others. I have this one. It holds everything that has a hole in it for hanging. All my patterns are on it and my rulers. Mine looks similar to this one . Not that pretty but functional.
Last edited by Onebyone; 11-11-2024 at 08:19 AM.
11-11-2024, 12:08 PM
#7
Super Member
Join Date: Jun 2008
Location: British Columbia
Posts: 2,640
I have a couple of peg boards and hang rulers on them. The ones I use the most often stand up in the bottom space of my cutting table. My only complaint about hanging rulers using their little hole is that the one I want might be at the back.
11-17-2024, 09:59 AM
#10
Super Member
Join Date: Jun 2009
Location: Tavistock, Ontario, Canada
Posts: 1,101
Plate Rack to Ruler Holder
I have a plate holder mounted above my cutting table for the longer rulers and keep the shorter ones in front directly on a bracket.
The cat shelf - I asked DH to add slots to the shelf for small rulers
The cat shelf - I asked DH to add slots to the shelf for small rulers
