Cross hatch quilting
#1
Member
Thread Starter
Join Date: Apr 2012
Location: Mukilteo, WA
Posts: 22
When I use cross hatch, or for that matter stitch in the ditch I do one direction and it goes great. When I go in the other direction, I often end up with a little fold when I cross over the previous stitching. Am I explaining it so it makes sense? Anyway, how can I avoid this? I iron, spray baste and then iron again. I don't know how I can make the quilt any flatter so this doesn't happen.
#2
Super Member
Join Date: Jul 2012
Location: Morris Plains, NJ
Posts: 1,821
Here’s a couple suggestions. Lengthen your stitch length and see if that makes a difference. Also, raise your presser foot up so it’s slightly above the fabric or loosen your presser foot pressure (check your machine manual for your particular machine). Hope this helps.
#4
Super Member
Join Date: Aug 2010
Posts: 2,426
Here’s a couple suggestions. Lengthen your stitch length and see if that makes a difference. Also, raise your presser foot up so it’s slightly above the fabric or loosen your presser foot pressure (check your machine manual for your particular machine). Hope this helps.
#5
I used to experience the little tucks like you. For me, I slow down and smooth out my quilt in the area where I am stitching. This leaves fewer lumps and bumps near where I will be crossing the first line of stitching. Seldom have the little fold overs now. The suggestions above do make good sense too.
#6
Super Member
Join Date: Aug 2009
Location: Illinois
Posts: 1,866
This is how I do it. When I'm coming close to that previous line of stitching, with needle down, I give a bit of a tug on the entire work and it helps work in what otherwise ends up as the tuck. I hope that explains it so it's understandable.
#9
Super Member
Join Date: Mar 2010
Location: Anchorage, AK
Posts: 1,414
Hope this makes sense! My trick is to use the flat of my hands to evenly distribute the excess fabric as I stitch the seam. If I lay both hands flat on the quilt, one on each side of the needle, gently pull hands apart while holding the fabric and let the machine pull the quilt through. By pulling the quilt taut like this, the excess fabric is evenly spread out over the length of my hands and the fabric that might have made a visible tuck at the next cross seam is evenly distributed across the area under my hands.

