Originally Posted by Karen Lynn (Post 5597204)

This is what I have to say I will pray for you, you have been given very good advice I have problems of very reasons. First I leave the room. pray, Take the face plate off and clean it, change the needle for no reason but to do it, rethread it, hand wheel the first couple stitches and go slow and usually it comes out all right. The Lord takes care of all things and I believs he will help you. God Bless. Karen from Freedom

Originally Posted by ArchaicArcane (Post 5586357)

Hi Eva,

Sorry for the long response, I was scrapping with a sewing machine and got a little carried away. :o

Yes, if A2 is flopping around, then it will cause issues. This is a pretty common problem. The easiest way to fix it, is to remove the needleplate, as if you were going to clean the feed dogs, and reposition the finger to the "upright" position, then carefully place the needle plate back down so that it straddles that finger.

I bet that fixes the problem. If it doesn't, let us know, and I'll post more about the timing issue. By the way, it's pretty rare for a FW to go out of time as far as I can tell, so that's why I said that working through all of the other suggested issues first are the way to go...

Easy as pie! I know you can do it.

Originally Posted by ArchaicArcane (Post 5612618)

No bother at all!!

There aren't any screws on either side of A2,.. that's part of B2 which should have lifted out of place with the needle plate.... Are they not moving out of place with the needle plate?

Do you have a picture you can post? I feel like I'm missing something. The needle plate, including B2, should lift out of place, then you put turn A2 into place, and drop the needle plate (and B2) on top then tighten the 2 screws back down.