SusieQOH

Hi all,

I have a FW that works great except for one thing- it hesitates before it starts to stitch. I have to touch the handwheel to "get it going". It happens a lot, but not all the time.

I oiled and lubed it just last week.

I was wondering if it could be the pedal or the motor? I really have no idea. Both are the originals.

TIA for any wisdom.

Tartan

You need to watch a video on adjusting the little nut in the foot pedal.

bkay

The best videos are on the 401a controller. Singer controllers are all the pretty much the same, prior to about 1960.

Mickey2

Like Tartan mentions, the pedal might need a bit of adjustment. Another thing that's very common is the need for more cleaning and oiling. If it's been stored away for a while, bit might need a bit of effort to get it running smooth again. Sometimes there are noticeable improvement after cleaning and regreasing the motor. Make sure the motor belt is clean, as well as the groove in the hand wheel and pulley; oil spill is common too.

I like the original motor and pedal and keep them. They are just as good as the replacement and with a bit of service run like new. Sometimes you can add grease to the wicks in the motor with out any furtehr; but on some machines the grease can be dry and clogg up the wicks. One or two drops of oil can soften the old grease and reach down to the bearings, but be very careful, only one or two drops literally. If oil dribble along the motor axle it will ruin the motor.

Mickey2

Another thing I forgot to mention; when I take out my 201K (belt driven motor) I some times have to run it a bit before the belt grips optimally. It doesn't happen all the time, but it now and then I have noticed it. Maybe it just needs a bit of warm up if it's cold. I think it was ArchaicArcane who compared it to car tires, they need to turn a bit to get optimal grip too.

Mickey2

What Cari? I have always been told to start with the needle down in the fabric, funny how we are given totally opposite advice sometimes.

SusieQOH

Thanks, everyone!
BKay- I heard that very thing from I believe The Featherweight Shop.(about oil ruining the motor). I hope this helps someone.
I'm going to do some work tomorrow. Thanks again, all!

coopah

Check Nova Montgomery's website with trouble-shooting of the electrical system. You may have carbon build up between the carbon brushes and the commutator. She has videos you can watch, too.

We just took her all day class and came away knowing so much! Plus our machines are now clean! Hubs cleaned one and I cleaned the other.

Bitord

Sounds like it just needs the wheel readjusted. There’s a screw behind the wheel, on the motor housing that move the motor back and forth. You just gently adjust the distance between the motor and the wheel until it runs, right away, when you touch the pedal. Also, be sure to start with the needle, truly, in the highest position.
i believe graphic instructions for doing both of these things, are on the Featherweight shop website.

Mickey2

Yeah, it might need a good shaking too and I think it would be a good idea if the owner jumps around the kitchen table on one foot with the Featherweight in her hands. It always does the trick.