Continuing problems with 1st attempt at machine quilting.
12-21-2016, 02:44 AM
#31
Super Member
Join Date: Jul 2008
Location: Keller, TX
Posts: 1,937
Lorli,
tell us how you are doing......was your thread coming out of the take up lever? If so, thread it from left to right, rather than right to left....it does a little wrap around the lever and does not effect your stitching.....later models of Janome have a latch on the lever that keeps the thread in.......so Janome knows of this isusue.
tell us how you are doing......was your thread coming out of the take up lever? If so, thread it from left to right, rather than right to left....it does a little wrap around the lever and does not effect your stitching.....later models of Janome have a latch on the lever that keeps the thread in.......so Janome knows of this isusue.
12-21-2016, 06:27 PM
#32
Member
Join Date: Aug 2011
Location: Omaha, NE
Posts: 51
When cleaning the 6600--remove the plate and also lift out the bobbin holder. Clean all the lint and fuzz out of the area and gently brush/wipe the bobbin holder. Put a drop or two of high quality sewing machine oil on the wick visible where the bobbin holder fits in. Replace the bobbin holder, matching the red dots. Screw down the plate. The machine should purr.
Also try turning the upper tension adjustment all the way left and all the way right, to make sure nothing is stuck. Then set at 4, or wherever you want it.
Just some ideas...
Also try turning the upper tension adjustment all the way left and all the way right, to make sure nothing is stuck. Then set at 4, or wherever you want it.
Just some ideas...
Thread
Thread Starter
Forum
Replies
Last Post
himnherr
Pictures
29
02-15-2012 07:47 AM
olmphoto2
General Chit-Chat (non-quilting talk)
62
03-02-2011 03:25 PM
