The long arm system depends on rolling the back and top seperately, with the batting floating between the two. Obviously, if they are stuck together or sprayed with a temp. adhesive, this would not be possible.

When quilting on my home sewing machine, I prepare my quilt sandwich by first clamping the backing with a slight amount of tension, to my cutting table. Usually, the back is wider than my cutting table, so I start in the middle by centering the fabric. After spraying the center of the back, I then center the relaxed batting gently spreading it out flat. I spray again and repeat with the quilt top. At this point, I will remove the binder clamps and move the entire sandwich to one side, where the basted side is clamped and then only the backing part clamped on the open side. Again with slight tension. This does not mean pulling, as when the quilt is unclamped it will attempt to return to original relaxed state. This will create distortion, and trust me you don't want distortion in a basted quilt. I repeat the process for the other unfinished side as well as the ends that were not covered on the first process.

When hand quilting, I use a thread baste method, because I do not use a hoop or frame. This method allows better control of the layers thru' all the manipulation required with this hand quilt process.

I share this information as lessons learned through trial and error. They are not meant as rules, as my experience has taught me that in quilting there really are no rules. What works for some doesn't work for others. I was sure I would never be able to hand quilt because I just couldn't get working on a frame or hoop. Out of desperation I took a class in hand quilting in hopes of discovering why I found it so darn hard! You can imagine my surprise at finding the quilting teacher teach without a hoop! For me it was an epiphany. Purely by accident, I found what works for me. Bottom line, try the methods recommended by lots of quilters, until you find what gives YOU the most success. Enjoy yourself, and fondle fabric every chance you get. :D

:-) Try this ,I put my Back & Batting on one roller which can be sprayed together then the Top on another. Hey, It works!!

:? I'd try the Spray,I got almost stabbed to death with all the pins in mine, Believe me I am gonna try the spray!OhYea'

So, if you use the spray you still have to baste or pin, right? I've never tried the spray before.

I love Sullivans basting spray! And I hate to admit that I have had a project sitting for almost 2 years :oops: and it is still fine, just the edges seem to have lost their 'stick' but the rest is still holding.

:? Ok I do the Longarming but with rolling it in on both sides, ya can do somewhat the same thing, and the spray would hold it down flat temporarily til you got the stitching in there you wanted. :wink:

:roll: O, I am wondering can you use the craft spray that says it's for fabrics?? :?

:( :?: Ok The spray might work don't really know, But hope it will on the smaller projects but will it work on everything??