Twister template
02-04-2012, 06:29 PM
#2
Super Member
Join Date: Jun 2011
Location: Michigan. . .FINALLY!!!!
Posts: 6,726
02-04-2012, 08:35 PM
#3
Power Poster
Join Date: Mar 2011
Location: Ontario, Canada
Posts: 41,460
Yes, you can make your own. I just used a square ruler from my collection and placed 2 pieces of clear tape across the top. I drew the lines on the tape with a sharpie. It worked okay and If you just want to do a wallhanging or tablerunner it's fine. If I wanted to make a quilt, I would buy the tool. It has cute little feet on the underside to keep the tool steady for cutting. At the time I made mine, I could not find the tool at my LQS.
02-04-2012, 08:43 PM
#4
Banned
Join Date: Mar 2010
Location: Sturbridge, Ma
Posts: 3,992
are you asking about templates for using the rotary cutter or to mark around"
For rotary cutter, many are going to Lowes or Home Depot and having them cut out of acyrlic
For home use - marking and then cutting, I get the template plastic from quilt shops, JoAnns etc.
So need to know what kind you mean.
For rotary cutter, many are going to Lowes or Home Depot and having them cut out of acyrlic
For home use - marking and then cutting, I get the template plastic from quilt shops, JoAnns etc.
So need to know what kind you mean.
02-05-2012, 01:52 AM
#6
Member
Join Date: Nov 2011
Location: London, UK
Posts: 53
In another thread this was discussed and I made note of the following thinking I would have a play at creating my own template.
"For the twister ruler :
The squares are always 1.5 inches square larger than your template......3.5 inch template =squares are cut 5 inches square... "
Unfortunately I did not make a note of the source of the information, so herein ends my knowledge on the subject.
"For the twister ruler :
The squares are always 1.5 inches square larger than your template......3.5 inch template =squares are cut 5 inches square... "
Unfortunately I did not make a note of the source of the information, so herein ends my knowledge on the subject.
02-05-2012, 08:14 PM
#7
Super Member
Join Date: Apr 2007
Location: Phoenix, AZ
Posts: 2,943
I go to my local plastics company with a drawing or printout of what I want the finished template to be. They then cut it out of acrylic plastic.
For the twister I would just mark each side with a pen or painters tape at the appropriate places and then I'd be ready.
I have used old Xray film in the past to make my own templates. The only hitch was that I had to destroy all the patient ID info, which was easy to do.
ali
For the twister I would just mark each side with a pen or painters tape at the appropriate places and then I'd be ready.
I have used old Xray film in the past to make my own templates. The only hitch was that I had to destroy all the patient ID info, which was easy to do.
ali
Thread
Thread Starter
Forum
Replies
Last Post
