[ATTACH=CONFIG]584296[/ATTACH][ATTACH=CONFIG]584297[/ATTACH]Don't know what you can tell from these. First is the backer on top of the fabric on top of the die. Then you crank that through the machine 2nd pic shows after you take it apart. There is a lot of static electricity so you just have to pick it all up piece by piece.
There are two pieces that are waste. And you will have that no matter what.
Mine are just not coming out right. Everyone else's look fine.
The backer was used extensively used to cut 2 1/2 strips. There are actually 5 strips on this die.
Last edited by Battle Axe; 11-24-2017 at 05:06 PM.
Reason: more info