Help!! Measuring Border for Out of Square Quilt
#1
Member
Thread Starter
Join Date: Jan 2013
Location: Winfield, West Virginia
Posts: 61
Help!! Measuring Border for Out of Square Quilt
Help!! I am at the point of adding borders for a quilt set on the diagonal. The middle measures 85" and the sides are 88-89". I am inclined to go with the middle measurement, but that is a big difference. Can I ease in 3-4" or do I need to try something in between?
#2
If you measure about 1/4 of the way down the quilt - 1/2 and then 3/4 - do you come up with the same as the middle measure of 85"?? Second - i am a little confused by your description that the "sides" are 88-89"....But i sure would not try to "ease" 3-4 inches...but that's just me.....a picture might help. PS....love your Maine Coon.
#4
A 3 or 4 inch difference is huge in terms of a quilt...I would try to figure out why there was such a big difference and correcting the errors ...this will help bring the quilt back closer to square and make it much easier to deal with borders....if you post a pic we may be able to see the problem areas and suggest the correct fix
#5
In general, with that big a difference in measurements, I would try to fix the problem with the center before adding borders. It will take a little more time, but you will save that time when you do the quilting.
#6
Super Member
Join Date: Jun 2011
Location: Illinois
Posts: 9,018
..and if your numbers are not consistently the same at all points usually it is recommended that you average out and use that figure....that is what I do, and sometimes you may have to wiggle or tug, but no wavy border that way
#7
Member
Thread Starter
Join Date: Jan 2013
Location: Winfield, West Virginia
Posts: 61
Thanks, Granny Dwynn, I re-measured, not measuring at the end. I must have been stretching the ends too much. It is now much closer and I feel better. I am so glad you experienced quilters are so willing to give your time and expertise to a beginning quiltmaker. The sides are still a little wavy. I tried to load a picture but I must be doing something wrong.
Thread
Thread Starter
Forum
Replies
Last Post