Tip from Man Sewing Rod Appell
03-02-2015, 11:30 AM
#11
Super Member
Join Date: Dec 2010
Location: Tennessee
Posts: 1,501
When I bought my first Bernina 15 years ago, that is what they told me to always do. I sometimes don't remember when changing thread on my Featherweight; but my Bernina is always unthreaded correctly. His other tip on always threading the needle with the presser foot up is a tip I need to remember. I think I can see the eye of the needle better with the presser food down. I wait until I am at the needle threading stage to lower the presser foot. Since the thread went through the tension disks with the foot up; hopefully my lowering the presser foot when I do is OK.
03-02-2015, 11:47 AM
#12
Super Member
Join Date: Jun 2012
Location: North Texas formerly The Burgh
Posts: 3,392
I don't even remember when / where i learned this....cuz for as long as i can remember, i've always clipped the thread at the top first feed and pulled it out "right way" through the needle......and i keep the presser foot up until i have pulled enough thread to amply thread the needle - then put it down to see the eye more clearly.
03-02-2015, 12:56 PM
#15
Power Poster
Join Date: Jan 2011
Location: Southern USA
Posts: 15,965
Originally Posted by nativetexan
I do that too. hate wasting thread so i always toss it near my needle holder. Big mess of threads but they are there if I need one!
03-02-2015, 01:09 PM
#16
Super Member
Join Date: Jan 2011
Location: Nawth o' Boston
Posts: 1,879
Originally Posted by Barb_MO
On the machine I use on my small quilting frame, I cute the thread at the spool and tie my new thread on it and then pull the whole thing through the needle, don't have to rethread the machine that way, never had any problems doing it that way. that cleans out a lot of lint along the thread path. I need to start doing that on my piecing machine.
What kind of knot do you use? square? weaver's? How short to you cut the ends?
03-02-2015, 01:59 PM
#17
Super Member
Join Date: Nov 2009
Location: Missouri
Posts: 2,485
Originally Posted by SueSew
I guess nice not to have to thread the needle? But I would worry tied ends would stick in there somewhere.
What kind of knot do you use? square? weaver's? How short to you cut the ends?
What kind of knot do you use? square? weaver's? How short to you cut the ends?
03-02-2015, 03:50 PM
#19
Super Member
Join Date: Aug 2010
Location: Piedmont Virginia in the Foothills of the Blue Ridge Mtns.
Posts: 8,562
I always teach this in classes too -- cut thread at spool, pull out thru the needle.
Same with bobbins -- remove bobbin from case leaving threads intact into the case. Cut thread at bobbin and pull thread thru bobbin case in same direction as it goes into the machine.
Jan in VA
Same with bobbins -- remove bobbin from case leaving threads intact into the case. Cut thread at bobbin and pull thread thru bobbin case in same direction as it goes into the machine.
Jan in VA
Thread
Thread Starter
Forum
Replies
Last Post
