Go Back  Quiltingboard Forums >
  • Main
  • Do you wash your batting? >
  • Do you wash your batting?

  • Do you wash your batting?

    Thread Tools
     
    Old 07-05-2015, 07:34 PM
      #1  
    Junior Member
    Thread Starter
     
    Join Date: Nov 2012
    Location: California
    Posts: 112
    Default Do you wash your batting?

    I always prewash my fabric but it just dawned on me that maybe I should also prewash the batting, should I?
    shortcake2012 is offline  
    Old 07-05-2015, 07:44 PM
      #2  
    Super Member
     
    Join Date: Jul 2014
    Location: Illinois
    Posts: 2,140
    Default

    No, but I do soak 100% cotton batting in the washer and line dry the batting. I honestly think it would almost certainly be fine to not pre-soak it, but I am really picky about getting rid of potential allergens.

    I definitely would not actually wash it. It distorts the batting too much & leaves it really wrinkly. I try not to apply too much heat to the batting. Just a tiny bit to get the fold marks out if I don't soak it first (e.g., with wool batting).

    The reason you don't need to pre-shrink the batting by washing it is because that 2% or so that it shrinks actually helps give the quilt that nice crinkly look.
    Bree123 is offline  
    Old 07-05-2015, 07:50 PM
      #3  
    Power Poster
     
    Join Date: May 2008
    Location: MN
    Posts: 24,474
    Default

    if it is washable, I wash mine. Read the instructions.

    I like a look that is as flat - and close to the original size - as possible.
    bearisgray is offline  
    Old 07-05-2015, 09:46 PM
      #4  
    Super Member
     
    Join Date: Oct 2013
    Location: Tulsa, Ok
    Posts: 4,582
    Default

    I preWash my cotton batting to reduce the crinkling in my finished quilts. By prewashing batting, I mean I soak it in hot water either in the sink or washer, then spin dry and dry in the dryer. I don't use the agitation cycle of the washer on batting. Comes out of the dryer just fine, very few wrinkles.
    Jeanne S is offline  
    Old 07-06-2015, 04:16 AM
      #5  
    Power Poster
     
    Join Date: Jun 2011
    Location: Southern California
    Posts: 19,127
    Default

    NO, you could have a total mess on your hands if you agitate it. I don't think it is worth the trouble. I use Hobbs 80/20 and sometimes due to their packaging, it may be quite wrinkled. I just throw it in a dryer on low heat with some wet towels and it comes out smooth and wrinkled free.
    ManiacQuilter2 is offline  
    Old 07-06-2015, 04:55 AM
      #6  
    Super Member
     
    Join Date: Mar 2011
    Location: Central NJ
    Posts: 5,571
    Default

    I pre-wash my fabrics as well but never my batting. I use W&N and like the crinkled look. I usually just make my quilts a bit over-size so the shrinkage isn't a factor.
    NJ Quilter is offline  
    Old 07-06-2015, 05:27 AM
      #7  
    Junior Member
    Thread Starter
     
    Join Date: Nov 2012
    Location: California
    Posts: 112
    Default

    Thank you so much for everyone's reply. I think it comes down to the look I want, wrinkled or more flat. I may wash my next one to see if it's worth the extra effort. Thanks again
    shortcake2012 is offline  
    Old 07-06-2015, 05:40 AM
      #8  
    Power Poster
     
    Join Date: Dec 2010
    Location: Michigan
    Posts: 11,276
    Default

    Originally Posted by shortcake2012
    Thank you so much for everyone's reply. I think it comes down to the look I want, wrinkled or more flat...
    This is basically what I do. Decide what look I'm going for. Most batting will have the instructions for pre shrinking on the packaging. If it's not there, check the manufacturer's web site. In general, you are trying to get the entire batt wet, not washed, so depending on the size of the piece I'm working with, I soak in laundry or bath tub, let it drain, roll in towels to press excess out, then dry on med heat. Don't agitate. Don't pull or stretch. Lots of dryer lint, so empty trap often & rearrange the batting in the dryer occasionally.
    PaperPrincess is offline  
    Old 07-06-2015, 07:06 AM
      #9  
    Super Member
     
    Buckeye Rose's Avatar
     
    Join Date: Jan 2011
    Location: Monroe, IN
    Posts: 2,283
    Default

    I prewash all my fabrics, but never the batting. If the prepackaged batting is wrinkled or poofy, I put it in the dryer with several wet washrags for about 15 minutes.
    Buckeye Rose is offline  
    Old 07-06-2015, 07:37 AM
      #10  
    Super Member
     
    Join Date: May 2013
    Location: Ballwin, MO
    Posts: 4,230
    Default

    I pre-shrink my batting, as I like to minimize the crinkle effect. The only one I've found with directions on the package is Warm and Natural, so I follow that same procedure with the others (as PaperPrincess describes). I haven't pre-shrunk a wool bat yet, as the projected shrinkage for those is less. Has anyone pre-soaked a wool bat with success?
    joe'smom is offline  
    Related Topics
    Thread
    Thread Starter
    Forum
    Replies
    Last Post
    Quinlog
    Main
    8
    04-23-2012 08:18 AM
    Julie in NM
    Main
    73
    08-08-2011 02:59 PM
    Veronica
    Main
    82
    01-21-2011 12:58 PM
    nursie76
    Main
    24
    08-04-2009 08:34 AM
    quiltswithdogs
    Main
    13
    05-29-2009 05:39 PM

    Posting Rules
    You may not post new threads
    You may not post replies
    You may not post attachments
    You may not edit your posts

    BB code is On
    Smilies are On
    [IMG] code is On
    HTML code is On
    Trackbacks are Off
    Pingbacks are Off
    Refbacks are Off



    FREE Quilting Newsletter