quilt aholic

Recently this Kenmore Rotary - 1948 Sewing Machine came into my acquisition. It was my hopes to be able to use it for free motion quilting. At last, through many hours of research, there is no darning foot available anywhere. Could anyone enlighten me?

lovelyl

I am not familiar with that machine. Do you know if the machine is low shank, high shank, or slant shank? Sew Classic (http://shop.sew-classic.com ) has generic darning feet for those type shanks. I haven't seen any for the super high shank machines, though. Good luck in your search.

KenmoreGal2

I FMQ on a slightly newer Kenmore, a 1956 model. It has a high shank foot. I use a darning foot. There is no name on the particular foot I use but it looks just like this Elna foot in the following Etsy link. It works great for me. I tried a hopping foot but did not have as much success with it.

Note - the foot pictured is low shank. I don't know what shank your machine is. I could not quickly find a picture of a high shank model.

https://www.etsy.com/listing/8778342...n-foot-vintage

MaggieLou

On my Kenmore 158, circa 1974, it says use the darning foot or no foot at all. Just use the needle. I would be very careful if I decided to use that approach. Mine has the super high shank.

quilt aholic

This Kenmore Rotary is a low shank with a fork connection.

MFord

Quilting without any foot at all is a dangerous games. Your fingers get too close to that sharp, sharp needle. You could ask me how I know all that...

Mickey2

Is this the right type fork fitting? I'm not sure but, I think there's a darning / free motion foot in the back to the left. With with a bit of search I'm sure one will turn up. Unless it's a very unusual type clamp they tend to turn up regularly but not the most common either.

quilt aholic

Yes, I have had to take a needle out of my finger a time or two.

quilt aholic

Thank you Mickey. That is the right type fork fitting, but the ones to the back left is 2 ruffle feet and 2 welding feet.

quilt aholic

Thank you all for your help and advice. Yesterday, I had a brainstorm. My son is a mechanist and can make anything, soooooo I took the parts that I wanted him to copy and make a darning foot. He said "it will be easy and I can have it done in a day."