Help with featherweight table
03-20-2011, 11:31 AM
#1
Power Poster
Thread Starter
Join Date: Mar 2009
Location: Lake Elsinore, CA
Posts: 15,143
I bought a featherweight with its table about 2 years ago. The previous owner had attempted to refinish the table's top, but didn't realize it was veneer, so he sanded it with a power sander and ruined it completely. I just had the veneer replaced and want to start using the table, but there's another problem. The insert (which comes out when the machine is in place) is missing some of the hardware, and I'm not sure how it should work, so do not know what kind of replacement hardware to get. These are some pictures of the under side of the table. There is a clip on one end of the insert that is attached by only one screw, but looks like it has had two screws in the past. That part clips onto the metal under the table top. The clips (or whatever) on the other end of the table are missing. Does anyone have one of these tables? Could you send me a picture of what should be there to support the insert when it's in the table? Or is there a place to order the missing hardware? TIA
03-20-2011, 12:37 PM
#2
Super Member
Join Date: Apr 2010
Location: Central Jersey & Calabash,NC
Posts: 4,024
Hi All, I haven't posted here in awhile--been busy sewing!! Here is a photo of my last aquisition--a 99K born in 1954--she needs some cleaning up and some adjusting but she runs fine otherwise.
03-20-2011, 02:33 PM
#3
Senior Member
Join Date: Feb 2011
Location: Louisiana
Posts: 476
Hope this helps.
Melinda
Melinda
Originally Posted by dunster
I bought a featherweight with its table about 2 years ago. The previous owner had attempted to refinish the table's top, but didn't realize it was veneer, so he sanded it with a power sander and ruined it completely. I just had the veneer replaced and want to start using the table, but there's another problem. The insert (which comes out when the machine is in place) is missing some of the hardware, and I'm not sure how it should work, so do not know what kind of replacement hardware to get. These are some pictures of the under side of the table. There is a clip on one end of the insert that is attached by only one screw, but looks like it has had two screws in the past. That part clips onto the metal under the table top. The clips (or whatever) on the other end of the table are missing. Does anyone have one of these tables? Could you send me a picture of what should be there to support the insert when it's in the table? Or is there a place to order the missing hardware? TIA
Thread
Thread Starter
Forum
Replies
Last Post
craftybear
For Vintage & Antique Machine Enthusiasts
1159
10-01-2016 11:14 AM
craftybear
Links and Resources
12
08-29-2011 11:36 PM
whinnytoo
For Vintage & Antique Machine Enthusiasts
12
06-07-2010 12:10 PM
