PATTIESPEARL

I have a singer 15-91 sewing machine that I bought from a lady on this board. The bobbin winder had broken in shipping. I found a bobbin winder frame from an old 201-2 and they interchanged. It even came with a wirking motor. The lead wire that goes to the motor on the new frame is brittle. can you rewire these? Where can I get information on these.

J Miller

PATTIESPEARL,

Here is a link to forum member Rayn or Rain ( can't remember which ) blog where he give very concise and detailed instructions on how to rewire motors, including the potted motors.
{ http://vssmb.blogspot.com/search/label/rewiring }

And then a thread I did not long ago with a few comments about rewiring them.
{ http://www.quiltingboard.com/vintage...r-t205360.html }

They might look complicated, but in reality they are very easy. Just follow the instructions in the blog.

Joe

jlhmnj

Motor wiring isn't bad but I'd be inclined to swap out BW parts or JB Weld before tinkering with motor. JB is good stuff and it won't even be noticed once it's touched up. Save and rewire the motor for another Singer project or spare.

Jon

Mizkaki

PATTIESPEARL,

The potted motor from the 201-2 and the 15-91 are identical and interchangeable, but the bobbinwinder is not.
The bobbinwinder parts are fairly easy to remove from the old broken 15-91 assembly and put on the 201-2's motor assembly. I have done this a fewl times.


Cathy

PATTIESPEARL

I did take the frame that I bought that came from the 201-s and installed it onto the 15-91. The bobbin winder works great, am just concerned about the brittle wire ot the motor on that one. In my mind, I should be able to take the motor with the good wire and put it into the frame that I now have on the machine. I have already tried the jb weld twice on the old frame. it sits at such a funny angle that the winder would not work.

PATTIESPEARL

i have even thought about slipping a piece of heat shrink tubing over the top of the wire and leaving it like that. the motor works very well.

jlhmnj

Good chance the wires are also in bad shape inside the motor out of view. Best to have them replaced for safety.

Jon

J Miller

I agree with Jon on this. When I did mine the two motor wires were devoid of insulation all the way up inside the motor. It was unsafe to even test run.

Joe

PATTIESPEARL

that is what i am afraid of. There should be a way to replace the wire going from the motor to the sewing machine

J Miller

Without disassembling the motor there isn't. Did you read the blog I posted the link to above? It is very detailed, but not overly complicated to rewire these motors.

Joe