Standard treadle owner needing knowledge - Help!

Reply Subscribe

Page 2 of 4

Thread Tools

12-24-2011, 08:40 PM

#11

HiDesertQuilter

Junior Member

Thread Starter

Join Date: Dec 2011

Location: Oregon High Desert

Posts: 137

Thanks for the offer on the manual. I'll be sure to let you know. Got to go make a pie. Merry Christmas everyone from Christmas Valley, Oregon!

12-24-2011, 08:42 PM

#12

Up North

Moderator

Join Date: Mar 2008

Location: North East Lower peninsula of Michigan

Posts: 6,231

I did clean mine up with Billy, lost in 51's tute used go jo and cotton balls she was not this nice looking when I got her. Yours will perk up a bit with some gentle cleaning.

__________________

12-26-2011, 05:38 AM

#13

Diamondrose

Junior Member

Join Date: Dec 2010

Location: The Bluegrass State

Posts: 167

It uses a 15 x 1 needle, so nothing special there. Mine is the same model, so I'd be happy to either email or snail mail a copy of my manual.

12-26-2011, 08:35 AM

#14

HiDesertQuilter

Junior Member

Thread Starter

Join Date: Dec 2011

Location: Oregon High Desert

Posts: 137

Email would be fine and I could just run it off on my printer. Also, I am needing a bobbin case to fit. The most common class 15 bobbin case has a finger pointing upwards. Does yours have this on it?
Thanks!

Last edited by Up North; 12-26-2011 at 09:13 AM. Reason: Email removed for security Use PM

12-26-2011, 09:11 AM

#15

Diamondrose

Junior Member

Join Date: Dec 2010

Location: The Bluegrass State

Posts: 167

I will email the manual. The bobbin case does not have a finger on it. There is a picture of one in the manual so you will be able to see what it looks like.

Just for your own information - it is best to pm someone with an email address. You may want to see if you can edit it out of your post.

12-26-2011, 12:05 PM

#16

HiDesertQuilter

Junior Member

Thread Starter

Join Date: Dec 2011

Location: Oregon High Desert

Posts: 137

What does 'pm' mean???? And thank you Up North for doing the edit! I'm learning! ;o)

12-26-2011, 12:09 PM

#17

Up North

Moderator

Join Date: Mar 2008

Location: North East Lower peninsula of Michigan

Posts: 6,231

Private Message click on the persons name that you want to send it to and you will get the option.

__________________

12-26-2011, 01:51 PM

#18

k9dancer

Super Member

Join Date: Aug 2010

Location: Mena, Arkansas

Posts: 1,351

Quote:

Originally Posted by Up North

[ATTACH=CONFIG]297623[/ATTACH][ATTACH=CONFIG]297625[/ATTACH]Here is mine

UoNorth, is this threaded properly? It looks wrong to me. I have never seen a machine where the thread goes through the take up lever before the tension.