I am new to the Quilting Board and have a question about binding a wall handing. I attached the binding and it came out very wavy. I removed it and started over. I am sure I have it squared up and ready to go again. I watched the online video explaining how to use glue and heat set. I tried that method on another small baby quilt and it worked great. But my problem is that I have machine appliqued pears that are going off the edge of the quilt sides. They still have a wave in them. I am assuming that is because of the quilting on them. Does any one have any suggestions that may help? Should I remove the pears and try to get it to lay flat without them? I also thought I could trim the wall hanging down a bit. The rest of the edges without the pears lay very flat. I hope this makes sense....Thanks so much for any suggestions.....