I'm back with questions, again. I think I messed good, or bad. After you cut the wedges with the first set of strata together, do you leave that and go to the next set and cut the second set of strata the same as the first with the dark on the bottom? Or do you use the first strata, turn it and continue on with the measurements. Then use the second set of strata for all the smaller wedges. I know I am not making myself clear but I don't know really how to explain it. Or does it mean that both sets of strata are used cutting the large numbers with the dark on the bottom. Here, do you cut all the pieces like the whole thing was two long pieces cutting 2l inches to 13 1/2 wedges, turning it and cutting 12 to 3 34 inch on the opposite side? I hope someone will understand what I am trying to say. If you only lived in my mind. I'm not going to cut anymore til I understand it. Thanks Blessings Kathryn