Originally Posted by GGinMcKinney
I was taught to begin by threading into the tiny hole by going inside the bobbin pushing thread to the outside, then pull the thread down the middle large hole that sits on the machine spindle. Before inserting into the bobbin area I trim the thread close to the bobbin.
I use thread all the way till the bobbin is empty with no issues. Had 6600 P over 2 years.
Hope this is helpful
Teresa in McKinney, TX
a new member
I do my bobbins the same way for my Janome 6600 as Theresa in McKinney, Tx. I've a 6500 and traded to a 6600 and have had this machine for 2 years. I've never had a problem other than running out of bobbin thread and not knowing for a minute or two. Good luck!!