The moose one was fine (in my opinion) until she got to the end where she makes it more difficult than it has to be. At that point, make sure the beginning is laying flat against the quilt edge (like she shows). Take the end and butt it up against the beginning tail and fold the excess back over itself and crease very well. We are going to assume you cut your binding strip 2-1/2" wide. Lay your ruler on this crease and cut off all but 2-1/2". Then just sew your diagonal seam, trim it to 1/4" inch, press it open and you are good to go. Works 100% of the time so long as you cut accurately.