I just purchased a walking foot and installed it on my Brother machine. I am doing some top stitching on a pot holder just around the edges where I turned under the edges. I used the zig zag stitch and found that it skips every once in awhile.
It does the zig but not the zag and then goes on to the next one. I can see a little needle hole where the thread should be but it isn't there. Otherwise it looks pretty good.
Other times when I've used the zig zag stitch I've had the same problem, and I wasn't using a walking foot at the time. So, I don't think it is the walking foot causing the problem.
Is this normal? I would like it to look perfect.
Any suggestions?