Originally Posted by emmah
Originally Posted by irishrose
Any ideas on how to keep the thread cutter on the 301 from sliding down? It seems to fit very tightly, but it slips down with use. Obvious answer - don't use it, but I'm accustomed to using a thread cutter.
Try sanding the pressure foot bar with a little fine sandpaper--or an emery board to roughen it up enough, then wipe with alcohol in case there is oil residue making it slip. That should help.
be careful not to let any of the alcohol drip on your paint, it will remove it very nicely.(the voice of experience) :cry: