Originally Posted by mom-6
I copied a picture of a celtic knot square I liked and made a wall hanging that needs to be on point for the look I want. When I pin it to my design wall it doesn't lay flat against the wall. It is approximately 27" square.
What can I do to correct this? I want it to hang nicely on my daughter's living room wall and not just flop around!
I don't really want to frame it (the obvious solution).
I did an octagonal wallhanging with the same problem. I added a rod pocket to the back at the largest point ( and with a square that would be fairly simple). Then get a small dowel rod to fit through it when it's hanging. It keeps the shape very nicely .