Originally Posted by
Glenn
Ok Lucy I see now, you plain good. Mark and drill holes use a 1/4 bit on the two sides of all boards. The holes should be 3/4" deep. Cut 1/4 diameter dowels (2ea) a less than 1 1/2" long. Woodglue and insert them. Put glue on all edges and mate them. Clamp on both sides with strap clamps. Four 1/4 holes and two dowels. Mark the location of the holes carefully so they align well.
Skip
Thaniks! Glad I could 'plain it this time. Any tips on making the marks accurate for the holes? I usually just measure from the edge(s) Laura