remove the bobbin plate tilt the machine back remove it's bobbin ect ,, so you can see the hook,
use what ever needle you have,, make sure the eye of that needle goes below the hook. if it only half way, then it won't work.
.often you can just lower the needle at the clamp, be sure you have it tight if you try that ,, not just finger tight,,
then thread it and rotate again ( backwards rotation ) again watch the hook, you'll see the loop form and the hook pick up the loop..
Thats the $70 timing the shop does , LOLOL ok they wipe it off and dump oil on.
Thats a FR and eveyone I have had took a 15x1
Last edited by xxxxxxxxxx; 06-24-2012 at 07:24 PM.