It's been a sewing kinda day [aside from the PT for the knee!!]
Just finished E3 and hope to handsew E4 tonight using EPP... on a roll only two behind!
For E3 I made the four center hst [halfsquare triangles] out of 2 1/2" squares of both fabrics, right side together & stitched 1/4" on either side of one diagonal line [hope all understand this that need to
] I also made four hst out of 2" squares of fabric for the outer corners and skewed them - that is I made sure there was more white than print fabric showing. I line up the diagonal line with the 7/8" marks on either side of my 3 1/2" square ruler - the print part of the hst was toward the 0-corner of the ruler. After making the pinwheel center and trimming to 3 1/4" [center point @ 1 5/8"] I cut 4 side pieces 3 1/4" x 1 1/2". The print of the triangle should line up with your inner seam that will be sewn to the center pinwheel. When you have attached first the two sides and then top/bottom borders with triangle corner squares as shown, trim your block to 5"[ATTACH=CONFIG]346969[/ATTACH]