Originally Posted by
dunster
If they are 6" blocks, cut each strip at 1.5" to finish at 1". The corner square, where you start, would be 3.5" unfinished to finish at 3".
I copied the square to my "draw" program which on my MAC is Claris works, so I can't e-mail it to you since unless you had the same program, you couldn't open it. Draw programs have rulers on each side of the window.
I measured the upper right square as 2.5" finished, not 3". I agree that the strips are 1" finished. That will give
you the center diagonal unit.
Then just use a triangle ruler to get the right sized triangles to complete the 6" square.
With son many triangles to cut, you would probably want to take the height of the triangle as your
strip set size and then cut many with your triangle ruler - first using the triangle ruler straight up and
then turning it 180º to get a triangle point down, thus maximizing how many triangles you get from
your strips. Good luck - if this is too confusing for you, then you need to call the shop owner and buy the pattern-Judy