Bev, no way could I sell the directions - after all the help I've received from you all!!
He bought a 10' section of 1" pvc pipe and cut it in two = (2) 5' sections.
Get (4) 1" pvc male adaptors, and (4) 1" pvc threaded caps.
(2) 1x4x2' boards for the ends, and then just cut the two holes in each of them.
I then used muslin for the 'leader cloths', which I taped on with packing tape! Ribbon and push pins make the side tension thingys.
And get maybe 3" or 4" pvc pipe (about 2' each?) to use as the supports, for it to slide on back & forth on, or how ever high you need.
He also later drilled holes in the pvc caps, and put dowels through them, to make it easier for me to tighten them. More like a faucet handle?
And yeap, Linda, it would slide much better I'm sure on pvc pipes, instead of the blocks of wood! lol!!! We were just pretty much using what we had on hand at the time. :wink:
Bev, I'm sending you an email too.
:D