Boston Block Hotpad - Lesson Three - Finishing the Hotpad
Okay now we are ready to finish the hotpad.
At this point you can choose to quilt the hotpad and add a binding.
I don't like bindings so I use the pillowcase method or the birthing method.
Place your top face down on the backing(face up)
[ATTACH=CONFIG]357196[/ATTACH]
Trim the backing to match the front
Pin the top and backing together
[ATTACH=CONFIG]357199[/ATTACH]
Lay the top on the batting and cut out 2 layers
slightly larger than your top
[ATTACH=CONFIG]357198[/ATTACH]
Make sure you put the top against
the batting. It makes it easier to sew
No seams to catch on the needle this way
[ATTACH=CONFIG]357200[/ATTACH]
Pin the top to the batting
and trim the batting
[ATTACH=CONFIG]357201[/ATTACH]
IF you want to use a loop
You can add it now.
Find the middle of one side and
sew on the loop. I fold it in half
and sew the two raw edges together.
then sew it to the edge of the hotpad
I use a shoestring for the loop.
[ATTACH=CONFIG]357202[/ATTACH]
I like to baste the border to the batting
so when you turn the hotpad right side out
the batting won't seperate
[ATTACH=CONFIG]357205[/ATTACH]
Now sew around the hotpad.
I leave an opening about 2" or so
to turn the hotpad through
[ATTACH=CONFIG]357204[/ATTACH]
Last edited by Rhonda; 08-22-2012 at 12:20 AM.