SteveH

Cool old square head screw
[ATTACH=CONFIG]385926[/ATTACH]

Removed... but ewwww
[ATTACH=CONFIG]385927[/ATTACH]

Since EVERYTHING is times off of this shaft, and it was set at the factory, I'm removing it but leaving it intact
[ATTACH=CONFIG]385928[/ATTACH]

Here you see left to right, drive movement arm and shaft bolt, Driveline (Belt,Needle bar cam, shuttle cam, feed dog cams on the right)
P.S. the little iron hammer to the right was the only tool my great grandfather brought with him from Sweden
[ATTACH=CONFIG]385929[/ATTACH]

Here is a closeup showing the underside, with the square head bolts,and the drift pin secured shuttle drive arm. (note the blob of solder, that is what secured the brass dist on the front)
[ATTACH=CONFIG]385930[/ATTACH]

One of my favorite discoveries, the feed dog bar is pivoted on mini cone bushings, like you see in treadles
[ATTACH=CONFIG]385931[/ATTACH]

The shuttle carrier mechanism
[ATTACH=CONFIG]385932[/ATTACH]

The removed body from the back (the Before shot...)
[ATTACH=CONFIG]385933[/ATTACH]

Ok then.. Note the back side of the drive arm is "lightened" (cost reduction) oh yeah, I did a little cleanup...
[ATTACH=CONFIG]385936[/ATTACH]