so here is the actual teardown.
I think this was a mostly display piece, the outside is so much cleaner that the inside, but no real wear
[ATTACH=CONFIG]390549[/ATTACH]
and HERE it begins.... this is the wooden base removed
[ATTACH=CONFIG]390550[/ATTACH]
This grease was so old and hard I needed to use a dental pick, oil and a wire brush to get it clean.
[ATTACH=CONFIG]390552[/ATTACH]
After reassembly, this was the first stitch (from the GOOD side....)
[ATTACH=CONFIG]390553[/ATTACH]
ok, rather than posting a 4 shot "reveal", here is the underside with the stitch attempts from right to left..
the original wild thing, then with a little bit of tension, then with the tension pretty snug.
[ATTACH=CONFIG]390554[/ATTACH]
"modeling shot" (note: check out the "test wiring" The twisted ends are just pressed into the receptacle. DO NOT DO THIS at home kids... )
[ATTACH=CONFIG]390555[/ATTACH]
Here is the shot showing the new end on my foot pedal. (it is actually a early outlet plug)
[ATTACH=CONFIG]390556[/ATTACH]
here was the first attempt, but later i just removed the splice and wired directly into the foot pedal
[ATTACH=CONFIG]390558[/ATTACH]
And For Nancy...here is my favorite part of the case kit... never even unpacked.
[ATTACH=CONFIG]390557[/ATTACH]
Some previous NERF repainted the case (and hinges, and latches....grrrr)
Last edited by SteveH; 01-25-2013 at 08:56 AM.