cathyvv

The text below is from a document that I think was on the Handiquilter web site, written by Dick Fuller. It's very helpful.

Top Thread Breaking
1. Try different thread or put thread in the refrigerator for several
hours.
2. Replace needle and ensure the scarf faces the throat of the
machine.
3. Check thread path. Re-thread the machine if necessary.
4. Use larger needle to reduce needle deflection.
5. Loosen fabric roller.
6. Adjust Needle-Bar so all of the Needle-Eye can be seen while
looking into the Hook Basket with the Bobbin Case removed.
7. Time: Turn machine forward with Hand Wheel and place the
POINT of the Sewing Hook in the middle of the scarf of the
Needle as it rises 3/32” (less than 1/8”) from the lowest position. The Hook should almost touch the Needle.
8. Polish Hook Point with fine (800) Emery Cloth.
9. Hopping Foot at the lowest point of it’s stroke should be the
thickness of one dime or three business cards.
10. Loosen top tension.
11. Tension Check Spring broken. It should be at 11 o’clock.
12. Turn thread cone/spool upside down.
13. Turn the Needle slightly to the right.

Loops on Under Side of Lining Fabric
1. Moving machine too fast for selected needle speed.
2. Tighten (to the right) top thread tension adjustment ¼ turn at
a time until corrected.
3. Clean under the Tension Spring on the Bobbin Case.
4. Bobbin thread not in tension spring delivery eye.
5. Put a sock on thread cone.
6. Check thread path on machine.
7. The stationary finger that holds the Hook Assembly and prevents it from turning should be ½ to 2/3 into the
depth of the notch.
8. Oil Bobbin Case.
9. Replace/repair Bobbin Backlash Spring.

Loose thread Tension on Top Fabric
1. Tighten Tension Adjustment (turn clockwise).
2. Loosen Bobbin tension.
3. Center the thread cone directly under the guide.

Machine Hard To Move
1. Raise Take Up Roller to clear the machine lower arm
by ½” to ¾” or the width of your finger.
2. Thread clogging wheel(s).
3. Center wheels on the track groove by adding or removing
washers.
4. Increase Hopping Foot height.

Skipped Stitches
1. Replace Needle, insert all the way up with the scarf
toward the throat of the machine.
2. Re-time (See #8 Top Thread Breaking).
3. Take-Up Roller too high.
4. Loosen Fabric Roller.
5. Polish Hook Point with fine (800) Emery Cloth.
6. Thread not on Check Spring Arm.
7. Check thread path on machine.
8. Hopping Foot too high.
9. Tension Check Spring at 11 o’clock with moderate resistance.
10. Correct gap between Needle and Hook.

Needle Breaking
1. Replace Needle and tighten Needle Set Screw.
2. Use larger needle.
3. Moving machine too fast for speed setting.
4. Re-time (See #8 Top Thread Breaking).

*Note on Timing: Adjust the Needle Bar height first. While in the lowest point of the stroke, look at the sewing hook, and the entire needle eye should be visible. None of the needle above the eye should be seen. Ensure the Needle Bar does not rotate from its original position before tightening.

A proper stitch has both the bottom and top threads meeting at the center of the layers. The top thread and take-up lever have much greater affect on tension adjustment than the bobbin tension. The take-up lever takes the slack out of the top thread as the needle comes up out of the fabric.

Thread can become wrapped around the encoder wheel, causing the stitch regulation mode to malfunction. Grasp the thread-end with tweezers and move the machine to pull and unravel the thread.