Here is what I posted last week for Janis.
"yours is a TS (transverse shuttle). All TSs take a 12x1 needle. AND most German TSs will work with the common industrial DBX1 needle.
Remember that the TSs do not have a needle stop for depth. Place the needle oriented the correct way (usually with the long groove facing forward), push it up to where you know its too high and clamp it down lightly. Turn the hand wheel towards you until the timing mark (an etched horizontal line on the top left of the needlebar) is just entering the casting. Now loosen and lower the needle until the eye is just entering the needle plate. Your needle is now set properly. See the thread:
Does anyone else have one of these?
Cathy
Originally Posted by
Janis
Mizkaki told me what needles would work on my machine.