Miriam,
Yes, 'setting it free' does require you to hold it down. But by cutting the notch it will stay under the screw (stay clamped down) and allow the auto stop to work (spring back action).
I figure that on some machines (due to casting & machining differences) the bracket might not reach far enough and holding down might always be needed. Since it does require a bit of fine tuning as to where to clamp it.
Cathy
Originally Posted by
miriam
Thank you looked into the notch.
Cathy I set it free of the bracket and it works as long as I hold the BW down but it doesn't spring back.
You do have to hold down the Spartan BW anyway.