While the set screws have to be loosened to remove the machine from the pins, Remember - THESE ARE IN THE MACHINE. don't remove the screws holding the hinges to the cabinet. there is another problem - with older ones, they normally have the foot pedal hard wired as a Knee Control into the cabinet. While you can remove the control easy enough, normally the wire runs through a small hole and the only way to deal with this is to cut the wire and rewire it at some point, or to remove the part where the cord plugs into the machine, and unwire the foot/knee control. I have seen so many with cut wires, and it is not a big deal to do that. Almost ALL of the electric machines I've removed from cabinets had this issue, except the 400 series as they have plugs that go underneath the machine.
Last edited by Macybaby; 09-12-2013 at 01:20 PM.