Rhonda's 2nd Boston Block Hotpad Class - Making the quilt top
Now here is the way I put together a Quilt block top for the hotpad.
This is the quilt block we are making:
[ATTACH=CONFIG]449789[/ATTACH]
In the last lesson we discussed how to make a Boston Block and the HSTs.
If you have those block units ready to go then we can start putting them together.
I like to divide the quilt block into 4 patch sections to sew together.
The bottom row are the 4 corners and the top row are the centers of each side. the pinwheel is the center of the design.
[ATTACH=CONFIG]449790[/ATTACH]
I lay them out and then lay the left square on top of the right square. then tack the left edge where the seam will go through
[ATTACH=CONFIG]449791[/ATTACH]
Here you can see all of them tacked on the seam ready to sew together
When you tack them you tack the left edge and then I turn them so they are set right to go under the needle.
[ATTACH=CONFIG]449794[/ATTACH]
Sew the seams and then iron the seam open on all of them.
[ATTACH=CONFIG]449792[/ATTACH]
Now place the sewn pairs of squares together into the 4 patches as shown above
Tack them in place and sew them together.
[ATTACH=CONFIG]449793[/ATTACH]
Last edited by Rhonda; 12-04-2013 at 02:52 AM.