The motor wires had been cut. I put a new spoked wheel on it and a hand crank. The bobbin area was fine. The bottom of the machine was fine. All I had to do was clean lint, dried oil and reoil to get the machine to work. After the DGKs go home I will take out the bobbin carrier and clean under there.
The shiny plates were filthy - some dawn and a rag and she got them nice and cleaned up.
The tension was filthy. Miss L is here so I let her pull it apart.
[ATTACH=CONFIG]468571[/ATTACH]
We laid the parts on a magnet to keep track of what way they go. Each piece was thoroughly cleaned. The little inside pin was somewhat rusted - Then we put it all back. The bobbin winder needed a bit of cleaning, too.
[ATTACH=CONFIG]468570[/ATTACH]