Originally Posted by
tulip43
I have a Janome 6600 with the 1/4" foot but am never sure where to move needle to. I bought the small 1/4" foot but cannot use the accu feed with it. Would like information from other 6600 owners about this
It's probably going to vary a little bit depending on which foot you're using...I use the 1/4" foot with the blade that came with my machine (also a 6600) and for THAT foot, I set my needle at 4.2 to get a good 1/4". But I'm not positive that will be the same for you. You'll have to test & check but that will probably be a good starting point. The key is to WRITE IT DOWN once you figure it out! I use post-its on the inside of the box that holds my feet to mark down needle positions. I actually reset my machine so that it automatically goes to the 4.2 setting when I turn the machine on, I have to punch a button to get it back to center, but since MOSTLY I do piecing on that machine it's perfect for me.