View Single Post
Old 12-07-2014, 02:10 PM
  #7  
toverly
Super Member
 
Join Date: Aug 2013
Location: Florida
Posts: 5,124
Default

The kneelift is addictive once you get used to it! Now that I think about it, you could have DH cut a rectangle the size of the little door in the table and use a block to fill the gap. Simply lifting out the piece to change the bobbin thread. I do lift mine out to clean. I have found that I don't need to lower the table once the machine itself was lowered down to table height.
toverly is offline