It's a 15-90 I pulled the motor from. The round thing is a microscope light-- lots of bright white LED's in a ring. I was hoping I could get it to fit around the needle and presser bar, but couldn't rig it so it didn't interfere with the thread path. I've stopped using it and have just gotten
more LED table lamps from Ikea that are positioned around the table, like this one:
[ATTACH=CONFIG]503354[/ATTACH]
the darning foot is a pretty standard one,
like this:
[ATTACH=CONFIG]503355[/ATTACH]
I also have a
finger guard installed from sew-classic.com:
[ATTACH=CONFIG]503356[/ATTACH]
It's a bit of a trick to get both of them installed without interfering with each other, but it's important to me to avoid piercing my finger. :-)